The derailment of a motorcycle chain is a serious and widespread problem, which can sometimes be very dangerous! Especially if it happens when you are stuck in traffic or driving on the freeway. You must therefore consider alternatives to minimize the risk of this happening…!
If your chain has started to derail frequently when it didn't before, something is probably wrong with your chain. motorcycle. The first thing to do is to make sure that your chain is properly tensioned. Then, you have to be careful that the links of your chain are not slack, and to make sure that the teeth of the crown and the pinion are not worn. Otherwise, always pay attention to warning signs that may indicate a failure in your chain. And try to spot them well to anticipate the chain derailment. In this article, find out all the possible reasons for your motorcycle chain derailment and how to prevent them:
Chain derailment caused by overly worn motorcycle crowns
The first cause of derailment of a motorcycle chain is the crown which must be worn due to time. Indeed, the motorcycle crown is considered to be one of the most important parts of the motorcycle. Located on the rear wheel, the crowns play an extremely important role in the final drive of a motorcycle. However, if they are worn, they can derail your chain and in particular reduce the performance of your machine.
Unfortunately, there is no quick fix to keeping the motorcycle crown brand new. The only solution is to maintain these parts, by cleaning it perfectly with a degreasing product. However, in the event that you notice that your crown has very sharp teeth. So, this means that they are already worn and there it will most likely be necessary to provide for an immediate change of your part.
However, if you see any rust punctures on your motorcycle chain, then we will redirect you to this article, which will give you all the possible solutions to this problem!
Motorcycle chain that derails because of a pinion that is too worn
Over time, the motorcycle's sprocket also wears out. This is usually recognized by the condition of the teeth on the sprockets. Which, when worn they become sharp and small and thus derail your motorcycle chain.
To solve this problem you will have to think about changing your complete chain kit! And replace the pinion and the crown of the rear wheel of your motorcycle.
Motorcycle chain which derails because it is not tight enough
Incorrect chain tension can also cause it to derail. This is the case when the latter is not tight enough, it can cause a systematic derailment of the motorcycle chain.
To remedy this problem, be sure to regularly check the tension of your motorcycle chain. Note that too tight a motorcycle chain can cause premature wear. It is therefore necessary to adjust its tension according to the value recommended by the manufacturer on the instructions.
However, the easiest method to tension a motorcycle chain is to measure the height of the chain at rest and check the correct alignment of the wheel. Once this is done, tighten the wheel if possible with a torque wrench while respecting the recommended tightening torque.
Motorcycle chain derailment due to poor alignment of the wheels
If your motorcycle chain tends to systematically derail, then it is likely that your wheel is misaligned.
To solve this problem, nothing could be simpler, you just have to use a ruler plated on the crown and check if it is in line with the chain. Finally, you have to try to adjust the left and right chain tensioners after loosening the locknuts of the motorcycle. If the problem persists, contact your repairer.
Some tips for maintaining a chain kit motorcycle
To prevent derailment and fall, cleaning and inspecting a motorcycle chain kit should be an integral part of any owner's regular maintenance. A chain left dirty and exposed to various external aggressions such as rain and dust, etc. It can lead to very costly problems down the road. For example, rain and salty roads in winter are important factors that can cause your chain and sprocket to wear out faster. On this subject, you can also consult this article, where we give you some effective tips to properly clean your motorcycle rims!
To prevent this from happening to you, it is therefore strongly recommended that you lubricate your chain kit. And to clean it carefully with a degreasing product to remove excess grease and dust, to be done every 1 km traveled. It is also necessary to remember to regularly check the tension of your chain to ensure the good functioning of your motorcycle as well as the safety of the rider.
